Do you have any instructions for the DT40 control panel?
Yes, please see the downloads section below.
Please note that if the DT40 screen displays the following error message: "C<" then the SmartMove position controller program might have been lost. In this case please refer to the seperate FAQ: http://www.gillardcutting.com/technical/faqs/what-does-c-mean-on-the-dt40
For more information please contact our Tech Team via email at: tech@gillardcutting.com
Downloads (PDF):
> DT40 Control panel - Combi machine (English).
> DT40 Control panel - Free-standing machine (English).
