Longitudinal slitter-puller for PE foam pipe & tube

To fully or partially cut along the length of foamed pipe

Our longitudinal slitter blade device can be integrated into any of our medium-duty caterpiller puller units.

As the foam pipe is hauled through the belts, it is also pulled past the fixed slitting blade. This creates a longitudinal cut along the upper surface of the product.

As the pipe is being slit it is supported by a nylon or PTFE guide block machined to match the pipe outer diameter.

The blade is height adjustable so that either a full or partial slit can be achieved. The up/down operation is controlled by an air cylinder.

The slitting device creates a very clean, straight, cut with little or no dust or debris.

It can be used on single or twin foam pipe.

Downloads